![]() Make sure the scribes are wide enough to allow drawers to open without hitting door and window casings or other obstructions on adjacent walls. It’s a good idea to plan for scribes early in the design process to get the overall length of the cabinet run right. The width of the scribe can vary depending on the installation. Frameless Cabinetsįrameless cabinets have a flat end so you need to build a scribe to fit the between the cabinet and the wall. Once you have a good fit you can fasten it in place. Test the fit occasionally to gauge your progress. It’s better to angle the edge slightly towards the back, since the back won’t be visible. Since you’re only sanding a 3/8″ thick edge, it will go quickly. If you use a belt sander be careful not to over sand or round off the edge. Sand the edge of the stile carefully down to the the pencil line. The line should feather to nothing where the gap was the widest. Hold the compass level and against the wall while you mark a pencil line to the bottom of the stile. Pull the cabinet about a 1/2″ from the wall and set the compass to match the widest part of the gap. One way to mark it is to use a pencil compass (remember the old geometry set from school?). Set the cabinet on the kick (or other support if it’s an upper cabinet) at the final height and slide it gently against the wall.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |